I made an application with OpenDCL and AutoCAD2012.
It all works very well.
Now I would like to make the porting to Bricscad V12.1.15
I'm using: Runtime OpenDCL [7.0.0.2]
Unfortunately, Bricscad displays the following error message: The OpenDCL Runtime module failed to load. Please repair the installation OpenDCL and try again.
Can you help me understand why?
Thanks in advance
Did you try reinstalling the 7.0.0.2 runtime module like the message suggested?
Is it possible the Bricscad was installed after the ODCL and therefore the original ODCL was not registered on the Bricscad?
Just a couple of thoughts.
Quote from: Danner on February 16, 2012, 06:46:26 AM
Did you try reinstalling like the message suggested?
Is it possible the Bricscad was installed after the ODCL and therefore the original ODCL was not registered on the Bricscad?
Just a couple of thoughts.
Thank you!
reinstalling the 7.0.0.2 runtime module now works well in Bricscad V12. :D
My pleasure Emiliano.
Its good to know everything is working well.
Dan
Yup, after re-installation, ODCL is working well...