Print Page - Ampersand sign " & " in Label Caption

Title: Ampersand sign " & " in Label Caption
Post by: khann on June 30, 2010, 06:31:40 PM

Hi.
How can I write " & " sign as it is in the Label Caption?
It changes to small " _ ".

Thanks. ;D

Title: Re: Ampersand sign " & " in Label Caption
Post by: BazzaCAD on June 30, 2010, 06:37:21 PM

Title: Re: Ampersand sign " & " in Label Caption
Post by: khann on June 30, 2010, 06:51:40 PM

So simple!
Thanks.

Then why single "&" changes to "_"?
What it means? ???

Title: Re: Ampersand sign " & " in Label Caption
Post by: owenwengerd on June 30, 2010, 07:48:05 PM

The ampersand is used to signify the accelerator for a control. It can be disabled, and perhaps should be. I'm not sure that it serves any purpose in OpenDCL dialogs.

Title: Re: Ampersand sign " & " in Label Caption
Post by: khann on June 30, 2010, 10:30:21 PM

Thanks, you two.
for the reply.

I'd like to test it. &Ok, &Cancel ... ^^*

OpenDCL Forums

OpenDCL => Runtime/AutoLISP => Topic started by: khann on June 30, 2010, 06:31:40 PM