Print Page - ControlBAr

Title: ControlBAr
Post by: aymen_ellouze on September 09, 2010, 01:45:48 AM

how to force the control bar to dock on the top of the command line or in the botton of toolbars?
(as it was with opendcl 4)

Title: Re: ControlBAr
Post by: Fred Tomke on September 09, 2010, 06:05:31 AM

Hello,

how about setting the form's property DockableSides to 3 (Top or Bottom)?

Fred

Title: Re: ControlBAr
Post by: aymen_ellouze on September 11, 2010, 04:36:14 AM

hi fred,

in fact it's already set, the problem is the start position.
as i already said it is docked on the bottom of the commandline and not on the TOP of it, or it is docked on the TOP of the ToolbarBars and connot be docked at the BOTTOM (as shown in the snap (made with opendDCL 4.0 few years ago...), and actually i can't obtain this result :(( )

thanks for the reply
and for anyone who can help

Title: Re: ControlBAr
Post by: aymen_ellouze on September 11, 2010, 04:45:48 AM

please focus on the postion of the ControlBar (it's the start postion), it's on the bottom of the controlBar...
i've also tried to get the same result with palette... do not work

Title: Re: ControlBAr
Post by: owenwengerd on September 12, 2010, 06:41:24 PM

I just tested a new control bar (with Dockable Sides set to 3) in AutoCAD 2011 and had no problem docking it either above or below the command line.

Title: Re: ControlBAr
Post by: aymen_ellouze on October 25, 2010, 06:01:05 AM

i made tests with version 6.0.1.2 :
- had no problem docking it either above or below the command line
- still unable to dock it below toolbars, as shown in the screen shot (it was odcl v4)

thx in advance

Title: Re: ControlBAr
Post by: aymen_ellouze on October 25, 2010, 07:08:05 AM

notice that in bricscad v10 control bars doesn't display properly, they always "remember" their initial size defined in the editor

OpenDCL Forums

OpenDCL => Runtime/AutoLISP => Topic started by: aymen_ellouze on September 09, 2010, 01:45:48 AM