Print Page - OpenDCL in Bricscad Classic

Title: OpenDCL in Bricscad Classic
Post by: Emiliano on September 13, 2012, 02:40:06 AM

Hello to all,
I'm trying to install the runtime 7.0.07 of OpenDCL in Bricscad V12 Classic.
Unfortunately, I always get the following error:

The OpenDCL Runtime module failed to load. Please repair the installation OpenDCL and try again.

OpenDCL is compatible with the Classic version of Bricscad, or you need the Professional version?
Thanks in advance.

Title: Re: OpenDCL in Bricscad Classic
Post by: Danner on September 13, 2012, 02:54:25 AM

You need the Pro or Platinum versions of Bricscad to use ODCL.

Classic does not support BRX (Bricscad Runtime Extension) as used by programs written in C/C++ such as ODCL.

Title: Re: OpenDCL in Bricscad Classic
Post by: Emiliano on September 13, 2012, 03:00:57 AM

Thanks for the reply ...

Too bad .... :'(

Title: Re: OpenDCL in Bricscad Classic
Post by: Danner on September 13, 2012, 04:33:29 AM

Sorry to be bearer of bad news.

However, happily its easy enough to upgrade from Classic to Pro and it doesn't cost much. 8)

OpenDCL Forums

OpenDCL => Runtime/AutoLISP => Topic started by: Emiliano on September 13, 2012, 02:40:06 AM