5.0.0.25
When I attempt to get the string of the currently selected block all I get is an error.
Load the BlockListTest.lsp file and type BlockList at the command line. Select a block from the BlockList and the hit the "Selection" button. An alert box should pop up with the name of the block.
Change dcl_ListView_GetItemText to dcl_BlockList_GetItemText, then it should work. BlockList controls used to be a special case of ListView, but they are now different controls.
Awsome!
This needs to get changed in the intelligent help. Do you want me to post something over at sourceforge?
Quote from: jb on October 06, 2008, 05:13:36 AM
Do you want me to post something over at sourceforge?
No, there is no need, as the intelligent help is going to be replaced soon.
QuoteNo, there is no need, as the intelligent help is going to be replaced soon.
You're not going to install Borg data ports in the sides of our necks are you? ???
"Resistence is . . ." well, you get it. ::)
Quote from: jb on October 07, 2008, 06:51:36 AM
You're not going to install Borg data ports in the sides of our necks are you? ???
I'd have to check, but I think those aren't scheduled until 2020...
OMG I was just kidding! :o