Remember position of palette

[Peter2]

I made a small palette (resizeable, dock all) and can it dock everywhere. Every position is remembered and restored when I restart Acad - nearly ...
When I dock it beneath or at the right of the command-line, then it is restored above the command-line (between drawing-area and command-line).

Is it possible to restore it right of the command-line?
(The lisp which calls the palette is started via the start-group (i hope this is the right name in English).

[owenwengerd]

If the problem is due to the command line loading after the palette loads, then perhaps you can delay loading of the palette via (dcl_DelayedInvoke).

[Peter2]

Yes, it was a timing problem with the command-line. "delayedinvoke" is fine, thanks.

But it is strange:
With every new drawing and new "delayed show of palette" the palette (which is docked right of the command-line) increases its width. Only 2-3 mm every time, but one time the command-line shrinked to 4 cm (2") and the palette took the rest.

[owenwengerd]

I'm not sure about the changing width. As a test, can you reproduce that when docking on the left, or in another position on the screen? It might be an AutoCAD bug, but requires further testing to determine the cause.

[Peter2]

JFYI

Yes, it was a timing problem with the command-line. "delayedinvoke" is fine, thanks....

Five years later I'm happy to find my own posting again and I have to confirm - yes, with current software-versions:
- same problem, same solution.