Ampersand sign " & " in Label Caption

Started by khann, June 30, 2010, 06:31:40 PM

Previous topic - Next topic

khann

Hi.
How can I write " & " sign as it is in the Label Caption?
It changes to small " _ ".

Thanks.  ;D

BazzaCAD

a.k.a.
Barry Ralphs
barryDOTralphsATgmailDOTcom

khann

So simple!
Thanks.

Then why single "&" changes to "_"?
What it means?  ???

owenwengerd

The ampersand is used to signify the accelerator for a control. It can be disabled, and perhaps should be. I'm not sure that it serves any purpose in OpenDCL dialogs.
Owen Wengerd (Outside The Box) / ManuSoft

khann

Thanks, you two.
for the reply.

I'd like to test it. &Ok, &Cancel ... ^^*